13 Tonne
Modular Spreader Frame
The MULTI-F13 is a 13 tonne modular spreader frame designed for four-point lifting applications where stability, controlled load distribution and flexible frame geometry are required. Built using modular corner points and interchangeable struts, the frame can be configured up to 6m x 6m to suit compact lifting arrangements and project-specific requirements.
Multi-F13 Capacity
By Frame Configuration
The Multi-F13 Modular Spreader Frame can be configured using different length and width combinations up to 6m in one direction. Working Load Limit varies depending on frame geometry and sling arrangement.
This load chart provides system capacity for standard configurations based on a maximum 30° STV (Sling to Vertical). Load charts for 45° STV configurations are available upon request.
| Width / Length | 1m | 2m | 3m | 4m | 5m | 6m |
|---|---|---|---|---|---|---|
| 1m | 13 | 9 | 8 | 7 | 7 | 7 |
| 2m | — | 13 | 9 | 9 | 9 | 9 |
| 3m | — | — | 13 | 13 | 13 | 13 |
| 4m | — | — | — | 13 | 13 | 13 |
| 5m | — | — | — | — | 13 | 13 |
| 6m | — | — | — | — | — | 13 |
Blank values indicate configurations not shown in the standard Multi-F13 chart. Final frame selection should always be verified against certified load data and the intended lifting arrangement.
Configuration Notes
- Assembled using Multi-13 modular struts and Multi-F13 corner units.
- Frame length and width must remain within the listed capacity chart.
- Capacity reduces on some narrow frame arrangements.
- Upper sling angle should be checked before confirming the lift.
- Final configuration should be reviewed by a competent lifting engineer.
Send us your load weight, lifting centres, required frame dimensions and sling arrangement, and our team can advise on the correct Multi-F13 configuration.